[phenixbb] what installer would work with a cluster with Darwin 9.8.0 if any?

Miguel Ortiz Lombardía miguel.ortiz-lombardia at afmb.univ-mrs.fr
Fri Jul 27 02:45:08 PDT 2012


Le 27/07/12 06:17, Tatyana Sysoeva a écrit :
> Hi all,
> 
> I am starting to use a new computer cluster and just found out by uname
> that it runs Darwin OS?
> It is totally new to me and I am wondering if Phenix would run on it?
> should I use just some Mac installer?
> 
> I would really appreciate any advices!
> Thank you!
> 
> Sincerely,
> Tanya
> 
> 
> _______________________________________________
> phenixbb mailing list
> phenixbb at phenix-online.org
> http://phenix-online.org/mailman/listinfo/phenixbb
> 
Hi Tanya,

I use the ones named

phenix-installer-<>-mac-intel-osx-x86_64.tar

You should check that your cluster is running at 64bit, otherwise select
the other similar installer (i386, I think)

I prefer the command-line installer because it gives more flexibility. I
use it like this

./install --prefix=/a/progs/xtal --no-apps

so I can choose where I want it installed and not to install the Mac
apps (normally you don't use them in a cluster since Macs do not share
their Aqua environment other than by "remote desktop" and that for a
single user)

Good luck!


-- 
Miguel

Architecture et Fonction des Macromolécules Biologiques (UMR7257)
CNRS, Aix-Marseille Université
Case 932, 163 Avenue de Luminy, 13288 Marseille cedex 9, France
Tel: +33(0) 491 82 55 93
Fax: +33(0) 491 26 67 20
mailto:miguel.ortiz-lombardia at afmb.univ-mrs.fr
http://w2.afmb.univ-mrs.fr/Miguel-Ortiz-Lombardia


More information about the phenixbb mailing list