Hi Mo, There isn't any place in the AutoBuild GUI specifically for "phases_from_resolve". If you really want to set this parameter you can go to the "uncommon inputs" window and set "resolve_command" to "phases_from_resolve". I think that you don't want to do this, however. I am assuming that this means that you are using a density-modified map as input to AutoBuild with data=my_density_modified_map.mtz. What you want to do instead is say (or set in the GUI): data=my_experimental_fobs_and_phases.mtz \ input_map_file=my_density_modified_map.mtz and then AutoBuild will start from your density modified map, but it will use experimental phase information as the prior phase information. It will also automatically set the parameter "phases_from_resolve" so that that you do not have to. I hope that helps! -Tom T Hi all, Can someone tell me where in the AutoBuild GUI I can set "phases_from_resolve"? I've looked for it in the "set variable" section, but it's not listed. Thanks! _______________________________________________ phenixbb mailing list [email protected] http://www.phenix-online.org/mailman/listinfo/phenixbb