On Wed, Oct 24, 2012 at 2:31 PM, Georg Mlynek
Dear All, MR rosetta crashed (too much programs running I guess) during rosetta rebuild and it tried to reattach but somehow did not work.
I have a rescoring_results.pkl and a place_model_results.pkl in my rosetta folder.
So I want to start with rosetta rebuild again.
1. Under Job_control I changed Start Point to rosetta rebuild. 2. When adding the rescoring_results.pkl I get following error message: PHENIX did not recognize the file type for /.../.../rescoring_results.pkl
What am I doing wrong?
Are you using the GUI? If so, you're not doing anything wrong, I am - this input isn't currently supported, but I will add it ASAP. (You may have to wait another few days for a new build, however, as some other stuff is currently broken.)
Is there a workaround?
Again, assuming you're using the GUI: set up all of the parameters except the results file, then instead of clicking "Run", select "Edit parameters and run", which depending on how the GUI is configured may require looking in the Actions menu. This will pop up a text editor, and you should set the mr_rosetta_solutions parameter to the full path of rescoring_results.pkl. Then save and exit the text editor, and continue. If you're using the command line, I guess this is a question for Tom... -Nat