Hi Luca,

I am sorry for the bug and the poor error message in resolve_cryo_em! 

Can you try this:

1. put all your copies of the sequence in the sequence file
2. set the parameter "copies of sequence file in map" to 1  (I think you set this to how many copies there were, which was quite reasonable to do but which does not work if there are no models).

I'll fix it so that this works ok in the future.
Thanks!
-Tom T

On Mon, Jan 22, 2024 at 10:16 AM Luca Pellegrini <lp212@cam.ac.uk> wrote:
Hi,

I am trying to run Resolve with two half maps and a sequence file with ncs copies of the sequence. Resolve stops with the message: “Need a symmetry file if ncs_copies > 1 and using models”. But I am not using models. Please advise.

Regards,
Luca

Luca Pellegrini, PhD
Department of Biochemistry
University of Cambridge
Cambridge CB2 1GA
UK




_______________________________________________
phenixbb mailing list
phenixbb@phenix-online.org
http://phenix-online.org/mailman/listinfo/phenixbb
Unsubscribe: phenixbb-leave@phenix-online.org


--
Thomas C Terwilliger
Laboratory Fellow, Los Alamos National Laboratory
Senior Scientist, New Mexico Consortium
100 Entrada Dr, Los Alamos, NM 87544
Tel: 505-431-0010