Hello, I am having difficulties defining NCS parameters using the GUI interface (Mac 10.4.11; phenix 1.6-289). Phenix will automatically select NCS restraint groups and use them during refinement. But if I edit the automated selections to my liking then click on Update and Save, the refinement runs with the original parameters unedited. I have tried reading in a ncs.param file, but it does not get read during the refinement run. Also, an intermittent problem with this GUI is that I am not allowed to "Add" a new restraint group. When I click this button, it just clears out the selections on the last group, and does not add a new group. Any ideas? Thanks. Best, John -- John Pascal, PhD ph 215.503.4596 Assistant Professor fx 215.923.2117 Thomas Jefferson University Biochemistry & Molecular Biology 233 South 10th Street, BLSB 804 Philadelphia, Pennsylvania 19107 ---------------------------------------------------------------- This message was sent using IMP, the Internet Messaging Program.