Hi Tom, Thank you for the information. This greatly helps me. Hongjun ________________________________________ From: [email protected] [[email protected]] on behalf of Terwilliger, Thomas C [[email protected]] Sent: Tuesday, March 06, 2012 1:43 PM To: PHENIX user mailing list Subject: Re: [phenixbb] where is the fo-fc omit map? Hi Hongjun, The omit map calculation only generates a 2Fo-Fc omit (or composite omit) map. I think however that for an omit map the 2Fo-Fc map and the Fo-Fc ought to look really similar, because in the omit region there are no contributions from the model. That's why the Fo-Fc map is not provided. The statement in the (old) documentation about using weights in the map is just so that you calculate the map with FP PHIM FOMM; however in recent versions of phenix you have FWT PHWT so you don't need any weights. I hope that helps! -Tom T ________________________________________ From: [email protected] [[email protected]] on behalf of Yu, Hongjun [[email protected]] Sent: Tuesday, March 06, 2012 11:31 AM To: [email protected] Subject: [phenixbb] where is the fo-fc omit map? hello, It is so good that phenix can caculate sa-omit map so easily. But I am new to this. When I finish caculating, I can only get acess to 2fo-fc map whe I use coot to open the file: resolve_composite_map.mtz . How can I open the fo-fc omit map? I notice this from phenix.autobuild manual page "Note 1: be sure to use the weights in both resolve_composite_map.mtz and omit_region.mtz". I don't understand this because the omit_regin.mtz seem to be the omit box I specify. Is this correlated with my problem? Any advice is appreciated. Thank you in advance! Sincerely, Hongjun _______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb _______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb