Hi, how do I reattach a job to a project in the GUI. Say I took the GUI to prepare a commands file (.eff) and save it. Then I run the actual refine from the command line on another computer using the save commands file. After the job is done, how do I get the job back in the GUI. I do not find something to „load“ or „reattach“ a job. Thanks. André André C. Stiel, Ph.D. (PI) +49 (0) 89 3187 3972 Office: Building 57, Room 009 Cell Engineering Group Institute of Biological and Medical Imaging Helmholtz Zentrum Muenchen Deutsches Forschungszentrum fuer Gesundheit und Umwelt (GmbH) Ingolstaedter Landstr. 1 85764 Neuherberg www.helmholtz-muenchen.de Aufsichtsratsvorsitzende: MinDir'in Baerbel Brumme-Bothe Geschaeftsfuehrer: Prof. Dr. Guenther Wess, Dr. Alfons Enhsen, Renate Schlusen (komm.) Registergericht: Amtsgericht Muenchen HRB 6466 USt-IdNr: DE 129521671