Dear Kaituo, I'm sorry for the problem! I'm not certain what went wrong in this case. It could be that the size of the structure is too big, or it could be a problem with autobuild, or it could be a problem with slow read/write to your file system. The error message "Unable to read ok_file...trying bigger version" will occur if resolve does not finish writing out the file "resolve.ok" immediately after finishing. If you are running on a system that is NFS-mounted, you might try instead running on the local disk. This might fix it. Otherwise, can you help me figure this out by eliminating other possibilities: 1. Can you tell me the version of phenix you are using and what machine this is on: echo $PHENIX_VERSION uname -a 2. Can you send me the entire log file AutoBuild_run_1_1.log 3. Can you send me the file AutoBuild_run_1_/TEMP0/temporary.com 4. If you are willing to send your data, that would be helpful: just tar up your data files and command file and then attach it to an email (but rename the file ".txt" so that it will get sent properly through my email system). Then I can try to reproduce the problem here. All the best, Tom T
My autobuild failed and the log file said: Columns used: labin FP=F SIGFP=SIGF FreeR_flag=FreeR_flag Unable to read ok_file...trying bigger version Failed to run resolve ---------------------------------- TRIED resolve ...but not OK
********************************************************************************Failed to carry out AutoBuild_set_up_build: failure
how t solve this? thanks
kaituo
peking University, Beijing _______________________________________________ phenixbb mailing list [email protected] http://www.phenix-online.org/mailman/listinfo/phenixbb