-----BEGIN PGP SIGNED MESSAGE----- Hash: SHA1 Dear all, I would like to run Phaser-EP through the phenix GUI. When I first uploaded the XDS_ASCII.HKL file, there was an error message about "No valid observed reflections found in this file". Subsequently I uploaded an unmerged hklf4 file. The GUI tells me I need to let phenix know about it being hklf4 by appending '=hklf4'. However, when I do so, there is an error message the file did not exist and the Data file line goes red. Where should I correctly append '=hklf4'? At the bottom, the message states it would be best to recover the original reflection data such as [...] XDS [...]. This suggests that the original XDS_ASCII.HKL could be used. Is this correct in if so, how do I put it into phenix? Best, Tim - -- - -- Dr Tim Gruene Institut fuer anorganische Chemie Tammannstr. 4 D-37077 Goettingen GPG Key ID = A46BEE1A -----BEGIN PGP SIGNATURE----- Version: GnuPG v1.4.12 (GNU/Linux) Comment: Using GnuPG with Icedove - http://www.enigmail.net/ iD8DBQFS1TDEUxlJ7aRr7hoRArKdAKDpXBrs4wsWMvWw0JNo8F746fY76ACfeFuG geGY6T6se8peE9dEGz8ETow= =AaLk -----END PGP SIGNATURE-----