Dear all: I would like to optimize my weights during Phenix refinement. I am running Phenix 1.6.4-486 using the gui, and I have checked the "optimize weights", but I cannot see the results of the optimization in the output, so I do not know the relationship between Rfree/geometry and wc and wxc_scale (I might not want to pick the automatically selected wxc_scale for the lowest Rfree, but would like to find a reasonable values to give me good geometry). Some earlier posts indicated that this is not output in the log file, but I am running a more recent version... Also, in case I wanted to adjust the weights manually, do I have set wxc_scale AND check the fix wc at the same time in the gui? Or just one of them? What would be typical values to start with at 2.8A (even if the answer depends on the particular data)? Same question for the ADP refinement.... I am working at 2.8A and my B factors are high (higher I think than what one would expect at this resolution). Thanks for your help, Alex -- Alexandra M. Deaconescu, Ph.D. Research Associate, HHMI c/o Grigorieff Laboratory Rosenstiel Center MS029 Brandeis University 415 South St. Waltham, MA 02454 phone: 781-736-2498 For FEDEX Brandeis University Kalman Receiving Dock 415 South St. Waltham, MA 02454