Re: [phenixbb] how to generate an isomorphous difference map

Good points. But also, the traditional isomorphous difference map is not as susceptible to model bias issues compared to a real space difference map (or a "vector" isomorphous difference map). On Tue, May 12, 2015 at 11:37 AM, Edward A. Berry wrote:

On 05/12/2015 09:46 AM, Philip Kiser wrote:

...

crystallogrphy,

If you did everything correctly, you should be able to directly calculate the difference map in Coot from the MTZ file generated by PHENIX. You would need to open it with "Open MTZ" rather than "Auto open MTZ" and then select the appropriate map coefficients. Note that what Tim described (a real space difference map) is technically different from the traditional isomorphous difference map where the SF amplitudes of the two data sets are subtracted prior to the map calculation.

Philip

Should be the same, due to linear property of the Fourier transform, EXCEPT for possible scaling differences and treatment of missing data. This latter could be significant, since presumably the traditional methods omits reflections unless present in both datasets, whereas in Tim's method each map will be made with all data available in that dataset. As a result, the largest coefficients in Tim's difference map might be the reflections which are absent in one map and present in the other. But if both have good completeness, it may not matter.

eab

...

On Tue, May 12, 2015 at 9:24 AM, Tim Gruene mailto:[email protected]> wrote:

Dear crystallogrphy,

you can open the PDB file with Coot, then use File -> Open MTZ to read one mtz-file after the other into Coot. Coot will offer to generate the map coefficients from the previously loaded PDB file.

Once you have both maps, you can go to Extensions -> Maps -> Make a Difference Map to create the difference map.

In order to see both positive and negative density, you choose Extensions -> Maps -> Set Map is a Difference Map.

Regards, Tim

On Tue, May 12, 2015 at 08:43:45PM +0800, crystallogrphy wrote: > Hi, > > I am trying to generate an isomorphous difference map with phenix GUI. I > input reflection 1 and 2 with mtz format and a PDB model, I got an MTZ > format map file. Because I want to load it to coot or pymol with negative > and positive density, I need to transform this mtz map to ccp4 map. > However, FFT map cannot work. > Does any know how can I get a ccp4 format maps with positive or negative > density? > > Thanks!

> _______________________________________________ > phenixbb mailing list > [email protected] mailto:[email protected] > http://phenix-online.org/mailman/listinfo/phenixbb > Unsubscribe: [email protected]

-- -- Dr Tim Gruene Institut fuer anorganische Chemie Tammannstr. 4 D-37077 Goettingen phone: +49 (0)551 39 22149 tel:%2B49%20%280%29551%2039%2022149

GPG Key ID = A46BEE1A

_______________________________________________ phenixbb mailing list [email protected] mailto:[email protected] http://phenix-online.org/mailman/listinfo/phenixbb Unsubscribe: [email protected]

_______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb Unsubscribe: [email protected]