Dear All, I would have a number of Phenix related questions: Firstly, I used the anisotropy server ( to anisotropically truncate my mtz file with anomalous signal (SAD data). My question is if the labels (for F+/F- and SIGF+/SIGF- are correctly recognized by Phenix (Autosol). The columns labels are: F_ref for FP; QSIGF_ref for SIGFP; GF(+)pk for F(+); LSIGF(+)pk for SIGF(+), GF(-)pk for F(-); LSIGF(-)pk for SIGF(-). It seems QSIGF and GF(+)pk/LSIGF(+)pk etc. are , but I am uncertain if it recognizes F_ref, because for the LABIN INPUT LABELS it says "NONE" for"F". Phenix does not seem to detect the anistropy ("Not using aniso- corrected data files as the range of aniso b is only 19.52 and 'correct_aniso' is not set); so I suppose I should use the correct_aniso=True keyword. Secondly, what are good values for the evaluation of the NCS mask and NCS averaging Resolve is using in Phenix; NCS overlap values (e.g. in my case 1.1) and NCS_CORR (in my case 0.52) in the "resolve.scores" file. Does an NCS overlap value of greater than 1 make sense? I am working with a (anisotropic) dataset with 4.1/4.5 A resolution, 78 % solvent content, 2-fold NCS; Perhaps a naive question: It is not possible to use B-factor sharpened maps for autobuilding with Phenix Autobuild is it? Thank you for any comments! Regards, Florian ----------------------------------------------------------- Florian Schmitzberger Biological Chemistry and Molecular Pharmacology Harvard Medical School 250 Longwood Avenue, SGM 130 Boston, MA 02115, US Tel: 001 617 432 5602