Dear all, I just wanted to post the solution to this incase anybody else runs into a similar problem. I just needed to compile the latest phenix (phenix-1.13-299) from source and now it works with my rosetta installation just fine. After downloading the source installer I changed into the install directory and ran: sudo ./install --prefix=/usr/local/stow --nproc=4 --try-unsupported --source --debug --rosetta --without-pymol (installed in non-standard location so as not to overwrite my binary installation) added source statement to .bashrc as instructed: source /usr/local/stow/phenix-1.13-2998/phenix_env.sh Since I had already compiled rosetta 3.7 (2016.32.58837) using scons as described: https://www.phenix-online.org/documentation/reference/rosetta_install.html https://www.rosettacommons.org/docs/latest/build_documentation/Build-Documen... I then ran: rosetta.build_phenix_interface_1.13-2998 nproc=4 rosetta.run_tests Cheers, Joseph. Joseph S. Brock | PhD Researcher Drew Lab Department of Biochemistry and Biophysics Stockholm University ________________________________ From: Joseph Brock Sent: Wednesday, 25 April 2018 10:38 PM To: [email protected] Subject: Phenix.rosetta build Ubuntu 16.04 Dear phenix community, I am trying to get phenix to run with rosetta on my Ubuntu 16.04 station. I am running the latest official phenix version (phenix-1.13-2998) and and compiled rosetta 3.7 (2016.32.58837) using scons as described: https://www.phenix-online.org/documentation/reference/rosetta_install.html https://www.rosettacommons.org/docs/latest/build_documentation/Build-Documen... Then ran rosetta.build_phenix_interface. All went without error but running rosetta.run_tests then gave the segmentation fault below. Defining variables as suggested did not help. I found a similar question in the phenixbb archives but no resolution: http://www.phenix-online.org/pipermail/phenixbb/2013-October/020274.html Any suggestions on how to move forward greatly appreciated! Cheers, Joseph. _________________________________________________________________________________________________________ Segmentation fault (Python and libc call stacks above) This crash may be due to a problem in any imported Python module, including modules which are not part of the cctbx project. To disable the traps leading to this message, define these environment variables (e.g. assign the value 1): BOOST_ADAPTBX_FPE_DEFAULT BOOST_ADAPTBX_SIGNALS_DEFAULT This will NOT solve the problem, just mask it, but may allow you to proceed in case it is not critical. Traceback (most recent call last): File "/usr/local/phenix-1.13-2998/build/../modules/phenix/phenix/command_line/rosetta_refine.py", line 305, in <module> run(sys.argv[1:], create_dir=True) File "/usr/local/phenix-1.13-2998/build/../modules/phenix/phenix/command_line/rosetta_refine.py", line 191, in run debug=params.output.debug) File "/usr/local/phenix-1.13-2998/modules/phenix/phenix/rosetta/refine.py", line 313, in __init__ self.run_jobs() File "/usr/local/phenix-1.13-2998/modules/phenix/phenix/rosetta/refine.py", line 388, in run_jobs check_result(result) File "/usr/local/phenix-1.13-2998/modules/phenix/phenix/rosetta/refine.py", line 379, in check_result raise RuntimeError("Aborted due to error in job %d." % result.job_id) RuntimeError: Aborted due to error in job 1. Joseph S. Brock | PhD Researcher Drew Lab Department of Biochemistry and Biophysics Stockholm University