Hi Ed, Thanks again for the question! The command phenix.autobuild after_autosol works if you have run autosol all the way through and obtained a model (as in your case); if you had no model (as in the test I ran to see if it worked), it would have stopped. I have fixed the problem so it should work in either case (starting tomorrow). All the best, Tom T On Dec 12, 2011, at 8:49 AM, Tom Terwilliger wrote:
Hi Ed,
You should be able to say
phenix.autobuild after_autosol
however I see that with the current version that does not work (it asks for a sequence file). Perhaps that is the reason for your question. I'll fix this.
All the best, Tom T
On Dec 12, 2011, at 8:13 AM, Edward A. Berry wrote:
Recently was mentioned a command to run autobuild automatically after autosolve- could someone remind me the syntax?
Thanks. Ed _______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb
Thomas C. Terwilliger Mail Stop M888 Los Alamos National Laboratory Los Alamos, NM 87545
Tel: 505-667-0072 email: [email protected] Fax: 505-665-3024 SOLVE web site: http://solve.lanl.gov PHENIX web site: http:www.phenix-online.org ISFI Integrated Center for Structure and Function Innovation web site: http://techcenter.mbi.ucla.edu TB Structural Genomics Consortium web site: http://www.doe-mbi.ucla.edu/TB CBSS Center for Bio-Security Science web site: http://www.lanl.gov/cbss
Thomas C. Terwilliger Mail Stop M888 Los Alamos National Laboratory Los Alamos, NM 87545 Tel: 505-667-0072 email: [email protected] Fax: 505-665-3024 SOLVE web site: http://solve.lanl.gov PHENIX web site: http:www.phenix-online.org ISFI Integrated Center for Structure and Function Innovation web site: http://techcenter.mbi.ucla.edu TB Structural Genomics Consortium web site: http://www.doe-mbi.ucla.edu/TB CBSS Center for Bio-Security Science web site: http://www.lanl.gov/cbss