Dear phenix developers, Last Friday (April 29) we upgraded phenix to its most recent version (1.7.1-743). Installation went smoothly on both Mac (10.6.7 64-bit) and Linux (Ubuntu 10.10 64-bit) machines. However, we observe that we cannot use phenix.refine (I don't know for the rest of the applications) from the GUI on the Macs. phenix.refine does work from the command line, though. So, whenever we try to add a pdb in the GUI, we get this error message: This application does not support the file type for /path/to/the/file.pdb (format: txt) If we try to open an mtz, it sometime works, but most often we get: PHENIX did not recognize the file type for /path/to/the/file.mtz! and on the terminal from where the GUI was started we can find: **SYMMETRY OPERATOR ERROR** Error in interpreting symop " X+2/3, Y+1/3, Z+1/3 " **SYMMETRY OPERATOR ERROR** Error in interpreting symop " -Y+2/3, X-Y+1/3, Z+1/3 " (and so on, so forth). Any clues ? Best regards, -- Miguel Architecture et Fonction des Macromolécules Biologiques (UMR6098) CNRS, Universités d'Aix-Marseille I & II Case 932, 163 Avenue de Luminy, 13288 Marseille cedex 9, France Tel: +33(0) 491 82 55 93 Fax: +33(0) 491 26 67 20 mailto:[email protected] http://www.afmb.univ-mrs.fr/Miguel-Ortiz-Lombardia -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean.