Hi Mark, I'm sorry, this must be a bug in the program. If you are running a recent version, can you possibly send me the input files and the full log file and I'll fix it? Thanks a lot! -Tom T ________________________________________ From: [email protected] [[email protected]] on behalf of Mark A Saper [[email protected]] Sent: Sunday, March 08, 2015 8:15 PM To: [email protected] Subject: [phenixbb] RESOLVE density modification I am trying to run RESOLVE density modification with the output of a SAD Phaser run (dev-1965). There are 3 input files: high resolution/experimental F’s and I’s, map coefficients and phases, and sequence. I consistently get this error: … ******************************************************************************** Failed to carry out AutoBuild_set_up_build: For finding NCS from sites an MTZ file is required ******************************************************************************** I do not know which MTZ file is being referred to. I have tried entering NCS as blank, 1, or turning it off in the NCS… options panel. I also tried including the substructure PDB file. Any suggestions? -Mark _________________________________ Mark A. Saper, Ph.D. Associate Professor of Biological Chemistry, University of Michigan Ann Arbor MI 48109-1055 U.S.A. [email protected] phone (734) 764-3353 fax (734) 764-3323 _______________________________________________ phenixbb mailing list [email protected] http://phenix-online.org/mailman/listinfo/phenixbb Unsubscribe: [email protected]