Hi Meindert, I am puzzled too! I'm sorry for the trouble. I just tested this with the same version of phenix you have (PHENIX VERSION: 1.3 of 11-08-2008): phenix.autobuild data=perfect.mtz model=coords.pdb multiple_models=True \ include_input_model=True multiple_models_number=1 n_cycle_rebuild_max=1 and this ran to completion with no problems. I wonder if there is something unusual about your PDB file? If you'd like to send me your files () I'll be happy to have a look. All the best, Tom T

Hi all,

I am a bit puzzled by an error message I get when trying to run phenix.autobuild. (I am using the latest/final version of phenix: PHENIX VERSION: 1.3 of 11-08-2008)

phenix.autobuild data=01.mtz model=3mei_coot.pdb multiple_models=True include_input_model=True \ multiple_models_number=1 n_cycle_rebuild_max=5

This gives me: **************************************** AutoBuild Input failed Sorry, multiple_models is only available with rebuild_in_place ****************************************

However, when I run the same commands using an older version of phenix (PHENIX VERSION: 1.3 of 23-03-2008), all runs fine.

Any ideas ?

Meindert

_______________________________________________ phenixbb mailing list [email protected] http://www.phenix-online.org/mailman/listinfo/phenixbb