[phenixbb] error on Autobuild GUI on new version (1.7.629)

YoungJin yjcho at brandeis.edu
Fri Jan 7 15:35:08 PST 2011

Thanks Nat.
I am out of the lab now. Let me check later and I'll let you know.
Thanks again.


On 1/7/11 5:35 PM, Nathaniel Echols wrote:
> On Fri, Jan 7, 2011 at 11:31 AM, Young-Jin Cho<yjcho at brandeis.edu>  wrote:
>> Hi Phenix developers,
>> I recently installed new version of phenix(phenix-1.7-629) FYI. I chose this installer version
>> phenix-installer-1.7-629-intel-linux-2.6-x86_64-fc3.tar as my computer indicates 2.6.18-194.17.4.el5 x86_64 after uname -rm command.
>> Everything was ok until I started AutoBuild program. Somehow it keeps giving me following error messages on my GUI window:
>> ********************************************************************************
>> Sorry, a subprocess has failed...
>> END OF LOG FILE /amnt/datnew/yjcho/RUN_FILE_2.log :
>> ImportError: numpy.core.multiarray failed to import
> I'm not sure what could cause this, because we use numpy sparingly,
> and it's usually imported in a way that would (hopefully) fail safely.
>   The GUI itself uses it for plotting, but this wouldn't explain why
> AutoBuild itself failed.  What happens when you run this command?
> phenix.wxpython -c "import numpy"
> thanks,
> Nat
> _______________________________________________
> phenixbb mailing list
> phenixbb at phenix-online.org
> http://phenix-online.org/mailman/listinfo/phenixbb

More information about the phenixbb mailing list