Building starting with a very poor map with parallel_autobuild

Authors

parallel_autobuild: Tom Terwilliger

Purpose

The goal of parallel_autobuild is to build models starting from very poor maps. In this situation most of the models created by autobuild are not very good, but some will be a little better than others. The strategy is to find these slightly-better models and iterate model-building based on them.

The working hypothesis for parallel_autobuild is that the quality of the starting map is a key determinant of how good the final model will be. The strategy is then to take a starting map and data, get the best model from this starting point, and use it to calculate a new starting map that is hopefully a little better than the first one. Iterating this process may finally lead to a starting map that is good enough to yield a complete model.

How parallel autobuild works

parallel_autobuild is a tool to carry out the process of picking good models from many autobuild runs automatically. It will run parallel jobs of phenix.autobuild, identify the best model and the corresponding map, then take the best map as the starting point for another cycle of building.

The choice of what is the best model is not always obvious. Parallel_autobuild uses the R-values of the models to make this choice if the R is less than 0.50 (by default), and if all R-values are higher, the map correlation of each model to its corresponding density-modified map is used to make the choice.

Inputs for parallel autobuild

The inputs for parallel autobuild are the same as for autobuild, with the addition of a few control parameters. Also parallel autobuild requires you to specify what each input file is (it won't guess). The main parameters are the number of processors to use, the number of overall cycles, and the number of parallel autobuild jobs to be run in each cycle. The number of processors available for each autobuild job then determines how many models are built in each autobuild cycle.

You can also specify whether the model obtained on each cycle is to be used in the next cycle (by default, if you supply a starting model the model obtained each cycle is used, and if you do not, it is tossed and only the new map is used.)

A run_command keyword allows you to specify how jobs are to be run. Parallel autobuild can be run on a queueing system (with a command such as qsub) or on a multiprocessor machine (e.g., with sh).

Possible Problems

Please note that for parallel_autobuild the input data file must be an MTZ file and it must have columns for FP SIGFP FreeR_flag. A convenient way to create the right file is to run phenix.autobuild with your data (you don't need to let it finish, just get started), then use the exptl_fobs_freeR_flags.mtz (or overall_best.refine_data.mtz) it creates as your data file for phenix.parallel_autobuild.

Specific limitations:

Parallel_autobuild does not recombine models from different parallel runs. It is possible that the use of phenix.combine_models with parallel_autobuild could further improve its performance.

References:

Keywords:

List of all available keywords