Re: [phenixbb] zero B-factors

Thanks a lot for all the answers :) Pavel was very kind to re-run my data with the latest version of the software and the problem was solved!! A great week to all, Edna Edna Patricia Matta, MSc. PhD Postdoctoral Fellow McGill University Goodman Cancer Centre 1160 Pine Avenue West, Room 614 Montreal, Quebec, CANADA, H3A 1A3 [http://www.med.mcgill.ca/nahum/images/tel.png] TEL: 1-514-398-7275 [http://www.med.mcgill.ca/nahum/images/fax.png] FAX: 1-514-398-1287 ________________________________ From: [email protected] [[email protected]] on behalf of Anshul Bhardwaj [[email protected]] Sent: Monday, November 18, 2013 3:02 PM To: PHENIX user mailing list Subject: Re: [phenixbb] zero B-factors Hello Edna, I am in the same boat, I had similar B-factor=0 problem with phenix.refine ver. 1.8_1069. Apparently, it was a bug in that specific version of PHENIX, which was fixed subsequently in later versions. Almost more than a year after PDB deposition to RCSB database, RCSB annotators found the issue and requested to send revised PDB with properly refined B-factors. The simplest solution is to refine the structure with latest official stable PHENIX version 1.8.4-1496, that takes care for the problem. Hope this helps! Best, Anshul Anshul Bhardwaj, Ph.D. Faculty, Department of Biochemistry and Molecular Biology Manager, Kimmel Cancer Center X-ray Crystallography and Molecular Interactions Thomas Jefferson University 233 South 10th Street, BLSB suite 822 Philadelphia, PA 19107 Tel: (215) 503-4587 [email protected] http://www.jefferson.edu/jmc/departments/biochemistry/faculty-staff/faculty/... http://www.kimmelcancercenter.org/kcc/kccnew/research/resources/xray/index.h... ________________________________ From: [email protected] on behalf of Edna Patricia Matta, Ms Sent: Saturday, November 16, 2013 12:37 AM To: [email protected] Subject: [phenixbb] zero B-factors Hello, Recently I did submit a structure to the PDB but they found that some atoms had zero value for the B-factors. I am new in this filed and I do not know what to do. There have been reports of problems with some versions of phenix about this. I used Phenix 1.8. I repeted the refinement doing restrain NCS-related B-factors but I do not find where to check for the the B-factor values in the the log file. Somebody can help me? Thanks a lot, Edna The information contained in this transmission contains privileged and confidential information. It is intended only for the use of the person named above. If you are not the intended recipient, you are hereby notified that any review, dissemination, distribution or duplication of this communication is strictly prohibited. If you are not the intended recipient, please contact the sender by reply email and destroy all copies of the original message. CAUTION: Intended recipients should NOT use email communication for emergent or urgent health care matters.