David, In your phenix parameter, select "phs" as map_coeffcients_format, the phs file can be read directly by xfit. Below is my parameter's map section: electron_density_maps { map_format = *xplor map_coefficients_format = *mtz *phs suppress = None map { mtz_label_amplitudes = "2FOFCWT_new" mtz_label_phases = "PH2FOFCWT_new" likelihood_weighted = True obs_factor = 2 calc_factor = 1 } map { mtz_label_amplitudes = "FOFCWT_new" mtz_label_phases = "PHFOFCWT_new" likelihood_weighted = True obs_factor = 1 calc_factor = 1 } } Regards, Tongqing Tongqing Zhou, Ph.D. Staff Scientist Structural Biology Section Vaccine Research Center, NIAID/NIH Building 40, Room 4607B 40 Convent Drive, MSC3027 Bethesda, MD 20892 (301) 594-8710 (Tel) (301) 793-0794 (Cell) (301) 480-2658 (Fax) ****************************************************************** The information in this e-mail and any of its attachments is confidential and may contain sensitive information. It should not be used by anyone who is not the original intended recipient. If you have received this e-mail in error please inform the sender and delete it from your mailbox or any other storage devices. National Institute of Allergy and Infectious Diseases shall not accept liability for any statements made that are sender's own and not expressly made on behalf of the NIAID by one of its representatives. ****************************************************************** From: David Shin [mailto:[email protected]] Sent: Tuesday, January 04, 2011 10:33 PM To: [email protected] Subject: [phenixbb] viewing maps in xfit Hi - Anyone have a script to convert phenix .mtz output so I can read in maps in xfit? I still find xfit handy for a few things. D